Wall Terminator

The Wall Terminator is our neat and simple solution to finishing a run of barriers. It is also a discreet and cost effective way to close off an alcove or side room in a gallery and consists of a short cylinder that terminates the elastic cord at the wall.

DIMENSIONS and FINISH

The Wall Terminators are 25mm dia’ by 20mm long and available in two hard wearing finishes:

	Wall Terminator - PPC Grey £14.00

	Wall Terminator - SS £13.00

ACCESSORIES FOR THE WALL TERMINATOR

You will of course require elasticated cord to go with your Wall Terminator.

USEFUL TIPS AND GUIDELINES

In the majority of layouts we recommend finishing a run of barriers by returning the cord to the wall as this helps prevent children and other misguided individuals from walking behind the barriers.

INSTALLATION INSTRUCTIONS

1. Remove the cap from the Wall Terminator and screw the main body to the wall with the centre at the same height as the elasticated cord on the barriers.
2. Pass the end of the cord through the hole in the cap until there is sufficient tension in the cord and tie a firm knot. Cut off any remaining cord close to the knot and screw the cap back onto the main body.